Equa-Press Lower Holders and Electrodes tuffaloy-logo

A lower, fixed, dual tip holder is offered for use with Equa-Press Holders. Like the Equa-Press, it has a standard two-inch tip spacing and helps make two welds at once, precisely alike. The standard trans-verse bar electrode shown is used when work geometry doesn’t require tips on the lower side. They are water-cooled.

36.0.0
36.1.1
Standard Lower Electrode
Part NumberPart DescriptionShank Diameter (in)
D
350-4020
40201
350-4021
40211 1/4
350-4022
40221 1/2
36.2.1
Standard Lower Holder
Part NumberPart DescriptionShank Diameter (in)Tip SpacingRWMA Taper No.
DAT
350-4030
4030125RW
350-4031
40311 1/425RW
350-4032
40321 1/225RW
36.3.1
Special Lower Holder
Part NumberPart DescriptionShank Diameter (in)Tip SpacingRWMA Taper No.Body Width (in)
DATW
350-4030-3
4030 with 1 1/4" to 2 7/8" centers11 1/4" to 2 7/8"4RW or 5RW4
350-4031-3
4031 with 1 1/4" to 2 7/8" centers1 1/41 1/4" to 2 7/8"4RW or 5RW4
350-4032-3
4032 with 1 1/4" to 2 7/8" centers1 1/21 1/4" to 2 7/8"4RW or 5RW4
350-8030-6
8030 with 3" to 6" centers13" to 6"4RW or 5RW8
350-8031-6
8031 with 3" to 6" centers1 1/43" to 6"4RW or 5RW8
350-8032-6
8032 with 3" to 6" centers1 1/23" to 6"4RW or 5RW8

When ordering, specify tip spacing ‘A’ and socket taper ‘T’

Navigation