Portable Resistance Weld Analyzer WS-80

WS-80 WeldScope

The WS-80 monitors the secondary current and cycle time of resistance welders during the welding cycle. The results are shown on a fluorescent display and can be sent to the included printer in both numeric and waveform format. The internal memory stores up to 800 data items measured consecutively. Any measurements that exceed the specified range are reported by visual alarm, buzzer sound, and a relay output.

Adobe_PDF_file_icon_32x32 WS-80 Weldscope Specification Sheet

Note: WS-80 Weldscope is a plug-in unit that requires an outlet within range of its power cord. For a battery powered hand-held device, T. J. Snow suggests and stocks the WS-100 or MM-315A.

Product Detail
Monitor Display:
  • Single Phase AC Spot and Seam Welders
  • Three Phase Frequency Converter & DC
  • Capacitor Discharge Welders
  • Inverter Welders
Detection Ranges:
  • Current – 0.5 to 100KA
  • Weld Time – 1 to 99 Cycles
  • Conduction Angle – 30 to 180 Degrees
  • Voltage – 0 to 9.99V
Detection Mode:
  • Impulse
  • Seam
  • Continuous
  • Capacitor Discharge
Printer:
  • Built-in thermal printer, capable of printing time-stamped weld data and waveforms.
Other:
  • Power Source 120VAC
  • Fluorescent Graphic Display
  • Dimensions: 9.44” (W) x 1 .44” (H) x 7” (D)
  • Weight: 16lbs
  • Waveform – Displays current waveform.
  • History – Stores 800 welds.
  • Numeric – Display current, weld time and conduction angle in an easy to read format.
  • System – Used to modify setup and configuration parameters.
  • Example of two different WeldScope WS-80 display options (below):
Inputs:
  • Pressure Signal
  • (4) Binary Select (Schedule Selection)
  • Voltage (Cables Not Included)
Outputs:
  • Weld Start
  • Good / No Good
  • Current Waveform
  • Voltage Waveform
  • RS-232

 

 

 

Navigation